- Sync Time With Ntp Server Windows 2016
- Synchronize Time With Ntp Server Download
- Linux Ntp Sync
- Synchronize Time With Ntp Server Ip
You can synchronize an event broker’s clock with a networked Network Time Protocol (NTP) server. This is especially helpful for event brokers that are using redundancy and/or Replication. For example, if your event brokers are synchronized with the same NTP server, message expiry times will be consistent across all of them.
Sync Time With Ntp Server Windows 2016
The procedure for synchronizing with an NTP server differs for appliances and software event brokers.
Synchronize Time With Ntp Server Download
Appliances
An appliance can be time synchronized using either the set up commands explained in Initial Set Up, or using the clock synchronization CLI commands shown below:
solace(configure)# clock
solace(configure/clock)# synchronization
solace(configure/clock/synchronization)# shutdown
solace(configure/clock/synchronization)# protocol ntp
solace(configure/clock/synchronization)# ntp-server <ip-addr>
solace(configure/clock/synchronization)# no shutdown
Linux Ntp Sync
![Synchronize Time With Ntp Server Synchronize Time With Ntp Server](/uploads/1/1/8/2/118237110/834707942.jpg)
Where:
ip-addr
is the IP address or fully qualified domain name (FQDN) of a reachable NTP server.
The no
version of this command, no ntp-server
, removes the NTP server information.
: If you need to reset the clock synchronization protocol to NTP, use the command solace(configure/clock/synchronization)# no protocol
Software Event Brokers
Software event broker clocks can be synchronized with one of the three methods shown in the following list.
: With the PubSub+ AWS AMI, clock synchronization is preconfigured to use AWS time servers. Use chronyd
to change the clock server.